Select the address from the following chart.VERY IMPORT ANT YOU MUST KNOW YOUR CODE (MASTER CODE) OR YOU WILL NOT BE ABLE TO CHANGE, ADD, DELETE, OR UPDATE THE USER CODES IN YOUR SYSTEM. If the LCD keypad is selected as something other than partition 1/ keypad 1 program the appropriate address in location 212. This will allow location 212 to be left at the factory default. If your system has an LCD keypad it is recommended that it be placed in partition 1 keypad 1. LOCATION 212 - PROGRAMMING THE LCD KEYPAD ADDRESS (1 segment of numerical data)Ĭertain commands in the NX-8E require it to know the location of at least 1 LCD keypad (if one exists in the system).
using address 192)? If not, check that panel programming location 212 is configured correctly. 21:03:09: failed to get name for zone 1 (no NX-148E present?) 21:03:08: Querying zone names and statuses. 21:03:08: Partition 1 status change: Sensor Battery Low, Last User = 001 21:03:08: Partition 1 status change: Ready The zone status request feature is enabled. There is an NX-184E keypad installed in the system. Nxgipd: communication problem, giving am having the same or similar problem. Partition 8 status change: Sensor Battery Low, Last User = 011 Partition 7 status change: Sensor Battery Low, Last User = 011 Partition 6 status change: Sensor Battery Low, Keyswitch Armed, Last User = 073 Partition 5 status change: Sensor Battery Low, Last User = 001 Partition 4 status change: Sensor Battery Low, Keyswitch Armed, Last User = 099 Partition 3 status change: Sensor Battery Low, Last User = Partition 2 status change: Sensor Battery Low, Last User = 073 Partition 1 status change: Sensor Battery Low, Keyswitch Armed, Last User = 073 Partition 6 status change: Ready, Chime Mode On Interface Firmware version v5.38 detected
nxgipdĭetected panel: NX-8E (maxzones=192, maxpartitions=8) I just tried again with Unit2 and got this.
0 kommentar(er)
